/* p10_2.c Stepper motor control
 *
 * This program controls a unipolar stepper motor using PTA7, 6, 5, 4.
 *
 * This program was tested with Keil uVision v5.23 with DFP v2.0.0.
 */
#include "stm32f0xx.h"

void delayMs(int n);
int main(void) {
    const char steps[ ] = {0x90, 0x30, 0x60, 0xC0};
    int i;

    /* PTA7, 6, 5, 4 for motor control */
    RCC->AHBENR |=  0x00020000;     /* enable GPIOA clock */
    GPIOA->MODER &= ~0x0000FF00;    /* clear pin mode */
    GPIOA->MODER |=  0x00005500;    /* set pins to output mode */

    for (;;) {
        GPIOA->ODR = steps[i++ & 3];   /* set the output pattern */
        delayMs(100);
    }
}

/* 8 MHz SYSCLK */
void delayMs(int n) {
    int i;
    for (; n > 0; n--)
        for (i = 0; i < 1142; i++) ;
}